Things to avoid/Troubleshooting

·        Don’t vacuum wet surfaces: This one is double trouble. Vacuuming a wet surface could result in both a damaged vacuum and electrocution for the operator.

 

·        Don’t allow your vacuum to sit in one place while it runs: The fact that the vacuum isn’t moving doesn’t mean that the vacuum brush isn’t still sweeping your carpet, so you may damage your carpet if you allow the vacuum to idle in one spot.

 

·        Don’t vacuum over the electrical cord: It’s possible that the cord will damage your vacuum, and, again, you face the possibility of damaging yourself as well.

 

·        Don’t vacuum without shoes: If your vacuum is raised even slightly off the floor, it’s possible that you could experience brush burns on your toes or feet.

 

Again, for troubleshooting your particular vacuum you’ll want to refer to your manual, but troubleshooting help for two common problems appears below:

 

·        The vacuum simply won’t run: Check your vacuum’s electrical cord first – is it connected securely to the vacuum and to the outlet? If the cord is, in fact, properly plugged in, check the outlet in order to make sure that it’s providing power.

 

·        Lack of suction: There are many, many things that can cause this problem. Begin by checking the dust bag if the vacuum is a traditional upright. Is it overflowing or not securely connected to the vacuum hose? If the bag isn’t the problem, check the vacuum nozzle as well in order to ensure that it’s not clogged, then check the vacuum brush and belt for problems.