|
|
Fitting Guide
Home » Motorcycling » Motorcycle Covers » Fitting GuideFirst check for rough edges (handgrip screw ends, brake and clutch lever ends, etc.), they must be smooth. DO NOT FIT AGAINST HOT PIPES.
Face the front of your bike and locate the logo on the cover. Place the left hole over the left mirror down to the base, repeat with right mirror, do not cinch yet. If you have bar-end mirrors, the mirror holes may not line up with them. If this is the case, or you do not have mirrors, the cover may be pulled over the mirrors and the holes cinched up by themselves.
Pull the motorcycle cover over the front fairing and headlights making sure you have covered both handgrips and front signal lights. (DO NOT fit over front fender.)
Grasp the rear of the motorcycle cover and pull over entire rear seat fairing and secure over the edge and sides, making sure the seat seams are even. (DO NOT fit over license plate, rear fender or rear signal lights.)
Readjust the front of the motorcycle cover over the hand grip and signal lights. Secure the foot peg straps around each foot peg base. Finally, cinch the mirror holes and adjust the cover to achieve a perfect fit.
To lock your motorcycle cover, run a cable lock through one mirror hole opening down along your front fork, passing through your front wheel disk and up through the other mirror hole opening. This will lock the entire front of the motorcycle cover as well as your front wheel, eliminating the need for a disk lock.
Related Motorcycle Covers Articles
- Motorcycle Covers Overview
- Motorcycle Covers Enhance Security and Protect From the Elements
- Fitting Guide
- Create a Pattern for a Motorcycle Cover
- Who Needs a Motorcycle Cover
- Selecting a Motorcycle Cover
- Enclosed Motorcycle Covers