How to Install Electrical Wiring

It doesn’t matter what you are trying to install in your home, electrical wiring is a big part of it. Even though you bought the wiring you need, it would be a great idea to understand how to handle certain situations so as to make your job much easier. Here are a series of helpful ideas on how to handle various electrical components that involve electrical wiring:

 

·        The Breaker Box: Before you even touch the breaker box, make sure the main switch is turned off. Think about this – the amount of electricity that comes into that breaker box from the street can kill. So be careful. After you have turned off the main power, bring the neutral and grounding wires into the box and attach them to the neutral bus bar. You do this by sticking the stripped ends into any hole of the bar and turn the screw head until tight.

·        Connecting the Wires: This is the most important part aside from the box. There can be more errors here, or else you may find your house up in flames because a short started a fire. When you are connecting wires, you must twist the wires together and connect them by using wire nuts. You do this by twisting the wire nuts on the twisted wires until it is tight. At this point, wrap electrical tape around the nut and wire to make sure you have a good secure connection.  

·        Wiring a Receptacle: When you are ready to begin hooking up the receptacle you need to make sure there is at least ¼ inch of bare wire to wrap around the screw. Take long-nose pliers and grab the white or neutral wire. Connect this to the silver side of the outlet. Now connect the black or hot wire to the brass side of the outlet. Of course the bare or green wire gets connected to ground by means of screw. After all wires are in place, it is a great idea to run electrical tape around the receptacle to prevent shorts just in case a wire somehow comes loose. Then push the receptacle in the box and screw it down. Then put the face plate on and screw that in.